The waveboard as a very unique a different design then most boards on the market. The board only has two wheels, which are free to rotate an entire 360 degrees, located under two separate decks that are connected by a spring loaded torsion bar. The decks are able to twist opposite of each other. It is this technology that allows the wave board to be propelled without your feet ever needing to touch the ground. The wheels are sized at 77mm and 85A, and the bearings are ABEC5. Waveboard wheels are designed to take the wear and tear of continual use. Your feet never have to touch the ground when riding and because of this any wheels would wear down much faster. The waveboard wheels keep you riding longer before you need to change them. The 360 degree meratol rotating wheels connect to the decks which are made out of high quality and very strong ABS plastic. ABS plastic was used because of the strength it has. The board can take a lot of wear and tear before it will ever break. The one draw back is that the board is slightly heavier then most boards, although weight is not going to matter when you are cruising down the street with the waveboard under your feet. On top of the decks are the face plates and grip. Outlining each deck are traction plates. These traction plates give you grip around the entire perimeter of each deck. Therefore if your feet slide for some reason the traction plates will grip your shoe and hold you on the board. In the middle of the top of each deck are the traction pads.